01
Phone Intake
We ask about the smell, the water history, the age of the building and any recent leaks. That call takes 10 minutes and lets us load the right gear. You get a two-hour arrival window and a text when the tech is en route.
02
Visual Walkthrough
The inspector walks every room, the attic, the crawl space and the mechanical closet. We photograph suspect areas and note building materials, insulation type and ventilation. This stage usually runs 30 to 45 minutes on a 1,500 sq ft home.
03
Moisture and Thermal Scan
We run a moisture meter across baseboards, window frames and ceilings, then confirm with a thermal imaging camera. A boroscope inspection camera goes into wall cavities where we cannot see. Anything above 16% moisture content gets flagged and mapped.
04
Air and Surface Sampling
We set an air sampling pump for 5 to 10 minutes per zone, indoor and outdoor, so the lab has a baseline. Tape lifts or swabs go on visible growth. Samples ship the same day and results come back in 24 to 48 hours.
05
Report and Walkthrough
You get a written report with photos, moisture readings, lab results and a recommended scope. We walk you through it by phone or on site and answer questions. If remediation is needed, we quote it; if it is not, we tell you that too.